Detcon 10/12 Control Card Test Fixture Bedienungsanleitung

Detcon Model 10/12 Control Card Test Fixture Operators Instruction Manual October 1, 2007 * Document 3385 * Revision 1.0 DETCON, Inc. 3200 Researc

Model 10/12 Control Card Test Fixture Page 10 of 10 Model 10C and 12C control cards. The Model 10C Facilities Module runs different firmware than a Mo

Model 10/12 Control Card Test Fixture Page 2 of 10 Table of Contents 1.0 Description 2.0 Features 3.0 Specifications 4.0 Operatio

Model 10/12 Control Card Test Fixture Page 3 of 10 1.0 Description Detcon Model 10/12 Control Card Test Fixture is designed to test the operation of

Model 10/12 Control Card Test Fixture Page 4 of 10 1 - Internal power supply and power switch 2 - Sensor power indicator LED (D4) 3 - mA output digit

Model 10/12 Control Card Test Fixture Page 5 of 10 Require tools: Digital Volt-Ohm Meter (DVM) Jewelers screwdriver NOTE: These instructions cover t

Model 10/12 Control Card Test Fixture Page 6 of 10 Turn SW1 clockwise until ALM1 and ALM2 LEDs on the Model 10 illuminate. Verify that the correspond

Model 10/12 Control Card Test Fixture Page 7 of 10 5 - Check alarm relay outputs. NOTE: Model 10C control cards are 2 alarm devices. Disregard the al

Model 10/12 Control Card Test Fixture Page 8 of 10 Variable R4 & 24 100 Flashing 20.0 Note: The Variable mA position is normally set for 20

Model 10/12 Control Card Test Fixture Page 9 of 10 2mA CAL 02.0 4mA 00 04.0 12mA 50 (±1) 12.0 Variable R4 & 24 100 20.0